OPEN IMPELLER · FIBROUS WATER
SS and SSM submersible sewage pumps
SS and SSM are submersible sewage pumps with an open impeller for water containing fibers. The catalogue distinguishes three-phase SS versions without a float switch from single-phase SSM variants fitted with a float switch, with hydraulic selection made from the model table.
Range technical data
- Power range
- 0.15–3 kW
- Maximum flow
- 60 m³/h
- Maximum head
- 22 m
- Electrical supply
- SS: 3~ 380–415 V, without float; SSM…F: 1~ 220–240 V, with float; 50 Hz
These figures describe the catalogue range or stated subrange. Maximum flow and maximum head/pressure are not a single duty point. Select the exact model from its curve and confirm materials, electrical version and connections.
Series catalogue ↗SS
A closer look at the series
The SS brochure groups two related electrical configurations under one wastewater family. The SS codes identify three-phase pumps without a float switch, while the SSM codes with an F suffix identify single-phase pumps fitted with one. An open impeller is stated for the series, together with suitability for water containing fibers.
The document lists a cast-iron outer motor casing, graphite-ceramic mechanical seal and rewindable motor. Application examples include sewage treatment, industrial drainage and agricultural irrigation. Flow and head vary by model; select from the tabulated Q–H data and verify the electrical and float-switch configuration rather than assuming all SS and SSM units are interchangeable.
Features
- Open-impeller hydraulic design
- SS three-phase versions without float switch
- SSM single-phase versions with float switch
- Cast-iron outer motor casing
Applications
- Sewage-treatment plants
- Industrial drainage
- Agricultural irrigation
Materials
G20 cast-iron outer motor casing, graphite–ceramic mechanical seal and shaft listed as AISI 304 SS–ASTM 5140. The brochure identifies an open impeller.
Operating conditions
Maximum liquid temperature +50 °C; suitable for water containing fibres. SS models are three-phase without a float switch; SSM…F models are single-phase with a float switch, as labelled in the catalogue.
Construction and application
Before selecting
- Select the flow–head point from the exact SS or SSM model row.
- Check liquid temperature and whether the liquid contains fibres.
- Confirm SS three-phase without float or SSM…F single-phase with float.
Your questions
Series questions
What is the difference between SS and SSM…F?
The brochure labels SS as three-phase without a float switch and SSM…F as single-phase with a float switch.
Are maximum flow and maximum head one operating point?
No. The table explicitly defines Q max at H = 0. Read the required head at the actual flow on the selected model curve.
Original catalogue
SS / PDF
Use the single-page SS/SSM table and its labelled electrical/float versions. Q max is expressly defined at H = 0, so read the required duty on the actual model curve.
Related series
WC
WC cutter submersible sewage pumps
The WC series combines a submersible sewage pump with a cutter for water containing fibrous material. The catalogue spans several discharge sizes and hydraulic curves, allowing the duty point to be checked for wastewater treatment, industrial drainage and agricultural irrigation.
FS
FS stainless-steel submersible pumps for light sewage
This FS catalogue covers AISI 304 submersible electric pumps for clean or slightly dirty water in domestic, workshop and industrial systems. It specifies solids passage by model and gives separate electrical variants, so the correct configuration depends on both liquid and duty point.
FS-INOX
FS stainless-steel submersible sewage pumps
The FS stainless-sewage range combines a double-channel impeller with AISI 304 wetted components. Its model range addresses clean water and sewage, with passage of suspended solids stated in the catalogue for each configuration rather than assumed across all FS pumps.